<del id="jotyd"><pre id="jotyd"></pre></del>
<th id="jotyd"><em id="jotyd"><pre id="jotyd"></pre></em></th>
        • Common abbreviations for OBD-II fault codes:

          2019-09-17 10:38:46 速銳得 514

          Common abbreviations for OBD-II fault codes:

          Circuit/open circuit

          "Circuit/open circuit" is mostly used when fixed values or high or low detection of specific circuits is not feasible. It can also be used with both low and high fault codes, provided that all three circuit conditions are detectable.

          2. Scope / performance

          “Range/Performance” means that the circuit is within normal operating range, but is not correct for current operating conditions. It can be used to indicate stuck or distorted values, display circuits, components, or systems that are not performing well.

          3. Low circuit

          “Low circuit” refers to the circuit voltage, frequency, or other characteristics measured at the input of the control module, which is below the normal operating range.

          4. High circuit

          “Circuit high” refers to the circuit voltage, frequency, or other characteristic measured at the input of the control module, which is higher than the normal operating range.

          5. Row

          "Powder" refers to a combination of cylinders that share a common control sensor. The first row always contains cylinder 1, and the second row refers to the opposite row.

          6. Sensor location

          The "sensor position" is either relative to the engine air flow: from the intake system to the exhaust system, or relative to the engine fuel flow: from the fuel tank to the engine, in the order of 1, 2, 3, etc.

          7. Left/Right and Front/Rear

          The "left/right and front/rear" positions of the components are assumed to be sitting in the driver's seat.

          8. A, B

          If the component is represented by a letter (for example, A, B, C, etc.), this is a manufacturer-defined value.

          9. Intermittent/unstable

          "Intermittent/unstable" means that the signal is temporarily discontinuous, but the duration of the fault is not sufficient to be considered an open or short circuit, or the rate of change is too high.

          other:

          One more thing to note. The OBD-II system uses a hexadecimal system. It uses 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F to count. For example, the next fault code for P029F is P02A0.


          无码孕妇一区二区三区,亚洲国产首页在线播放,伊人久久男人的天堂,最新国产精品 久
          <del id="jotyd"><pre id="jotyd"></pre></del>
          <th id="jotyd"><em id="jotyd"><pre id="jotyd"></pre></em></th>
              • 在线看永久AV毛片| 亚洲自慰白浆无码专区| 99精品热在线高清观看视频| 国产午夜三级在线播放| 91午夜色国产在线| 亚洲无码专区在线视频| 色吊丝中文字幕性无码专区| 香蕉国产精品偷在看视频| 精品人妻无码在线小视频| 久久精品66免费99精品网站| 国产精品99一区不卡| 97无码人妻视频在线| AV无码国产精品性色aⅴ| 国产日韩欧美久久一区| 久久综合午夜网站| 亚洲另类激情综合偷自拍图| 亚洲国产中文在线视频| AV在线免费不卡可看| 国产亚洲真人做受在线观看|